Data logger Baykal-8 v.3

A high-resolution 6-channels seismic data logger "Baikal-8" can be used for recording the signals from external seismic or various sensors with high precision and synchronization with UTC. 

The device can be used for long-term seismic and geophysical measurements including operations under field conditions. 

The Ethernet support allows for using the standard solutions for connecting several devices into a network. FTP and SeedLink support gives possibilities to use the standard software for remote data retrieval.

Characteristics Delivery and warranty

Sensitivity axes
Clip level 5 mm/sec
Frequency range 0.008 (120 sec) - 40 Hz
Dynamic range at 1 Hz
Cross-axes sensitivity
Non-linearity at 1 Hz1
Temperature range -40°C - +55°C - extended range
Supply voltage 10.5-30 V DC, single-ended. Nominal value – 12 V
Power consumption < 600 mW
Cold-start time 15-45 min
Maximum installation tilt
Leveling, mass locking
Noise performance
Intrinsic noise
Connector type FQ24-10Z
Delivery set FQ24-10Z type cable, 8 Gb MicroSD card, GPS antenna
Weight 2.2 kg
Dimensions 170 х 80 х 180 mm
Case rugged case for field surveys
Data transfer USB 2.0, Wi-Fi
Data storage 32 Gb (flash)
Inbuilt sensors for device health monitoring
ADC noise performance
GNSS timing accuracy < 1µs
ADC sampling rate 1, 10, 50, 100, 250, 500, 1000 Hz
GNSS receiver GPS / GLONASS
Data recording mode Continuous, Schedule
Gain coefficients 1, 2, 4, 8, 16, 32, 64
Data recording format Internal binary, miniSeed, SEG converters provided
ADC sampling rate 24 bit